Owner-Operated · Licensed & Insured
Paver Cleaning & Sealing in Sarasota, FL
Deep clean, mechanical prep, joint sand reset, and professional-grade Ure-Seal H2O — built for Florida's heat, UV, and humidity.
Paver Cleaning & Sealing
Most paver sealing companies spray a product and leave. Kelly K's preps the surface first. We use mechanical diamond grinding on heavily stained or previously sealed pavers to make sure the sealer bonds directly to the actual paver — not a layer of old product, efflorescence, or residue. Then we seal with Ure-Seal H2O, a water-based aliphatic urethane built specifically for Florida's UV exposure, intense heat, and humidity. It stays flexible, won't yellow, and won't crack.
Joint sand is reset with polymer-free product before sealing. We don't use polymeric sand on Sarasota installations — Florida's rain and humidity cause it to fail before it fully cures, and removing failed polymeric sand is a significantly bigger job than using the right material from the start.
Why It Matters
What Sarasota's Climate Does to Unsealed Pavers
Sarasota's combination of Gulf salt air, intense UV, summer downpours exceeding two inches per hour, and year-round humidity puts paver surfaces under constant stress. No other region compounds these four factors the way the Gulf Coast does — and unsealed pavers show it fast.
Our Process
Paver Sealing in Sarasota, Step by Step
We walk the surface, identify paver type, check for prior sealers, and discuss your finish preference. Sealer selection follows the assessment — not what's already on the truck. We pick the right product for your specific installation.
Deep clean to bare surface. Heavily stained or previously sealed pavers get mechanical prep with a diamond cup wheel to ensure direct paver-to-sealer adhesion. Oil and rust stains are spot-treated before the general clean. This is the step most companies skip.
Joint sand lost during cleaning is replaced with fresh polymer-free joint sand before the surface dries. Properly filled joints keep pavers stable after sealing. We don't use polymeric sand — Florida's humidity prevents it from curing correctly.
Pavers must be fully dry before sealer application. In Sarasota's humidity that means 24–48 hours of dry weather. We don't schedule sealing days when the 48-hour forecast shows significant precipitation. Moisture trapped under sealer causes premature failure.
Two coats of Ure-Seal H2O with measured coverage documented on the work order. UV-stable, flexible under Florida heat, won't yellow or crack. Slip-resistant top coat applied to pool decks and wet-area walkways.
Written cure instructions provided before we leave. The owner walks the entire surface with you at completion. Every job is documented with before and after photos. If anything isn't right, we fix it before the invoice is issued.
What's Included
Full-Service Paver Cleaning & Sealing Package
- Initial assessment & sealer consultation
- Deep surface pressure cleaning
- Targeted stain pre-treatment (oil, rust, efflorescence)
- Mechanical diamond grinding where required
- Joint sand evaluation and reset
- Controlled drying period monitoring
- Two-coat Ure-Seal H2O application
- Slip-resistant top coat on wet-area surfaces
- Before & after photo documentation
- Written cure instructions
- Final walkthrough with the owner
- Satisfaction guarantee — no exceptions
What Customers Say
Real Results on Sarasota Pavers
“Our travertine pool deck hadn't been sealed in years and had significant algae streaking. Dalton assessed the surface, prepped it properly, and the result is honestly better than when it was installed. No one else offered the mechanical prep.”
“We'd had two other companies seal our driveway and it always failed within a year. Kelly K's explained exactly why — they were sealing over residue instead of prepping to bare paver. Two years later ours still looks great.”
“Owner shows up, assesses, explains what needs to happen, and does it. No mystery about what product they're using or why. The slip-resistant coat on the pool edge was a detail I didn't even think to ask about.”
“Hired Kelly K's for a paver driveway with old failed sealer from a previous company. They removed the old product, treated the efflorescence, and sealed with Ure-Seal. Night and day difference. Professional from start to finish.”
✅ Satisfaction Guaranteed — Every Paver Job
We walk the property with you before we leave. If the result doesn't meet what we committed to, we make it right before any invoice is issued. Every job includes before and after photo documentation. No exceptions, no arguments.
Paver Cleaning & Sealing — Sarasota FAQ
How often do pavers need to be sealed in Sarasota?
Why don't you use polymeric sand?
What is Ure-Seal H2O and why do you use it?
What does mechanical prep (diamond grinding) mean?
Will sealing change how my pavers look?
Can you seal pavers that were already sealed by someone else?
Will my pool deck be slippery after sealing?
How long do I need to stay off the pavers after sealing?
Why is there no pricing listed online?
Paver cleaning & sealing across Sarasota, Bradenton, Lakewood Ranch, Venice, Siesta Key & Longboat Key.
Ready to Protect Your Pavers?
Free on-site assessment. Written quote. No pressure — just honest advice about what your specific pavers need.
📞 Call (941) 504-7660 Request Free Estimate →Paver Results
Drag the slider to see real paver cleaning and sealing results.
Get a Free On-Site Estimate
$100 off your first service · We respond same day. No sales pressure — just a straightforward quote based on a real look at your property.
Or call us directly: (941) 504-7660 · We respond same day.